Spray-on Cells – Turn Anything Into A Solar Panel

Forget large, bulky solar panels. Soon anything from clothing to cars could be used to harness energy from the sun.

Scientists from Sheffield have developed low-cost, spray-on solar cells that can be applied to small surfaces in a similar way to paint. The cells are made of a material called perovskite, which is cheap to produce and, when used as a spray, produces very little waste. This, along with the fact the spray can be easily mass produced, means manufacturing costs are low, which ultimately means prices would be lower for customers.

In theory, the spray could be used on any surface that the cells can stick to, however, its efficiency is likely to be affected on flexible surfaces, or fabrics.

SOLAR PANEL EFFICIENCY

Around 85 per cent of photovoltaics currently used are made from crystalline silicon.  It is expensive to produce and typically has a conversion rate of 25 per cent, on average.

The material used in the spray-on cells is perovskite. Perovskite is a term used to describe the mineral crystal structure found in the calcium titanium oxide mineral species, made of calcium titanate. It was first used for solar cells in 2009, but efficiency was poor. The Sheffield team found that by spray-painting the perovskite they could make prototype solar cells with efficiency of up to 19 per cent. The team of scientists from the University of Sheffield is the first to make perovskite solar cells using this spray painting technique.

By spray-painting the perovskite layer in the air, the team hope the overall energy used to make a solar cell can be reduced further.

He added: ‘The perovskite devices we have created still use similar structures to organic cells. What we have done is replace the key light absorbing layer – the organic layer – with a spray-painted perovskite. ‘Using a perovskite absorber instead of an organic absorber gives a significant boost in terms of efficiency.’

Lead researcher Professor David Lidzey said: ‘There isa lot of excitement around perovskite-based photovoltaics. Remarkably, this class of material offers the potential to combine the high performance of mature solar cell technologies with the low embedded energy costs of production of organic photovoltaics.’ While most solar cells are manufactured using energy intensive materials, perovskites, by comparison, require much less energy to make.

Professor Lidzey said: ‘This study is a significant step towards efficient, low-cost solar cell devices made using high volume roll-to-roll processing methods. ‘I believe that new thin-film photovoltaic technologies are going to have an important role to play in driving the uptake of solar-energy, and that perovskite based cells are emerging as likely thin-film candidates.’

Source: DailyMail

Share This: